Billy Goat BG1002SP User Manual download pdf (Page 12)

Part No. 800012 Form No. F021402A

Page 12 of 12

Purchased

from

Purchase

Date

1803 S. Jefferson P.O. Box 308

Lee's Summit, MO 64063 / USA

(816) 524-9666 (816) 524-6983

Model

Serial No.

lbs

Engine Power

Unit (weight)

h p

Solution

Problem Possible Cause

TROUBLESHOOTING

Before Requesting Service Review These Suggestions

2121

22.122.1

22.1

2222

Engine Service and Warranty

Contact your nearest engine manufacturer's autho-

rized servicing dealer.

Serial Plate

Record your machine model, serial number

and date-of-purchase and where purchased

Will not vacuum or has poor

vacuum performance.

Clean debris bag. Shake bag clean or wash. Adjust nozzle height.

Check for hose kit cap. Unclog nozzle or exhaust (see page 5).

Allow air to feed with debris.

2020

Dirty debris bag. Nozzle height set too high or too low. Hose kit cap

missing. Clogged nozzle or exhaust. Excessive quantity of debris.

Engine is locked, will not

pull over.

Debris locked inside impeller. Engine problem.

See page 5, Contact an engine servicing dealer for engine problems.

See Chain Adjustments on page 11.

Noisy or broken chain

Self propelled drive will not

release

Sticking belt idler arm. Belt fingers out of adjustment, bent or broken.

Check idler. Idler arm mounting screw may be too tight or too

loose. Check wire belt guide adjustment. Replace if broken. (see

fig. 3 & 4 adjustment on page 11).

No self-propelling

Check transmission gear selection. Check clutch cable

adjustment and belt and chain (See page 11).

Engine will not start.

Check stop switches, throttle, and gasoline. Connect spark plug wire.

Clean or replace air cleaner. Or contact a qualified service person.

Abnormal vibration.

Check impeller and replace if required. Check Engine.

Loose or out of balance impeller or loose engine.

Throttle in off position. Out of gasoline. Bad or old gasoline.

Spark Plug wire disconnected. Dirty air cleaner.

Transmission not in gear. Operator's bail not engaging belt or out of

adjustment. Worn out or broken belt. Broken or mispositioned belt.

No chain lubrication. Chain out of alignment or over tensioned.

CAUTION

READ OWNER'S MANUAL

BEFORE OPERATING, MAKE SURE:

USE PROTECTION

EXHAUST ELBOW IS ATTACHED.

EXHAUST IS DISCHARGING INTO

ENCLOSED CONTAINER.

ALL GUARDS ARE ATTACHED.

HOSE IS ATTACHED.

USE ONLY A QUALIFIED MECHANIC TO SERVICE THIS MACHINE.

INSPECT MACHINE BEFORE EACH USE AND REPLACE ANY

WORN AND DAMAGED PARTS.

ABRASIVE DEBRIS WILL SHORTEN UNIT LIFE.

830138

OPERATING INSTRUCTION IS OBTAINED.

STOP ENGINE AND ALLOW TO

COOL BEFORE REFUELING.

KEEP ENGINE CLEAN OF DEBRIS.

PROPERLY SECURE EQUIPMENT BEFORE TRANSPORTING.

NEVER SERVICE UNIT WITHOUT DISCONNECTING SPARK PLUG WIRE.

Reference: Label CAUTION

Part No. 830138

BILLY GOAT INDUSTRIES INC.

1803 S.W. JEFFERSON STREET; LEE'S SUMMIT, MO 64082-2312 / USA

PHONE: 816-524-9666 FAX: 816-524-6983 www.billygoat.com

WARRANTY PROCEDURE

Please fill in the WARRANTY CARD and send the upper part to Billy Goat.

The WARRANTY terms are stated on the lower part which remains with the

user. Whenever a Billy Goat Machine is faulty due to a defect in material

and / or workmanship, the owner should make a warranty claim as follows:

The Machine should be taken to the dealer from whom it was

purchased or to an authorized Billy Goat dealer.

The owner should present the remaining half of the Warranty

Registration Card, or, if this is not available, the invoice or receipt.

The Warranty Claim will be filled in by the authorized Billy Goat Dealer,

who will send it with the faulty part to Billy Goat headquarters.

The Quality / Service department at Billy Goat headquarters will study

the claim and parts and will notify their conclusions.

The decision by the Quality / Service department at Billy Goat

headquarters to approve or reject a Warranty claim is final and

binding.

Note:

To process a Warranty Claim, it is necessary to quote the Model

& Serial number who are printed on the Billy Goat Serial Plate.

118 dB

1 2 ... 7 8 9 10 11 12

Comments to this Manuals

No comments

Billy Goat BG1002SP User Manual Page 12

Comments to this Manuals

Related products and manuals for Garden tools Billy Goat BG1002SP