Billy Goat QB1004 User Manual download pdf (Page 2)

Part No. 430316 Form No. F012203A

WARNING: DO NOT

1. DO NOT run engine in an enclosed area.

Exhaust gases contain carbon monoxide, an

odorless and deadly poison.

2. DO NOT place hands or feet near moving

or rotating parts.

3. DO NOT store, spill or use gasoline near

an open flame, or devices such as a stove,

furnace, or water heater which use a pilot

light or devices which can create a spark.

4. DO NOT refuel indoors where area is not

well ventilated. Outdoor refueling is recom-

mended.

5. DO NOT fill fuel tank while engine is

running. Allow engine to cool for 2 minutes

before refueling. Store fuel in approved

safety containers.

6. DO NOT remove fuel tank cap while

engine is running.

7. DO NOT operate engine when smell of

gasoline is present or other explosive

conditions exist.

8. DO NOT operate engine if gasoline is

spilled. Move machine away from the spill

and avoid creating any ignition until the

gasoline has evaporated.

9. DO NOT transport unit with fuel in tank.

10. DO NOT smoke when filling fuel tank.

11. DO NOT choke carburetor to stop engine.

Whenever possible, gradually reduce engine

speed before stopping.

12. DO NOT run engine at excessive speeds.

This may result in injury & /or damage

to unit.

Page 2 of 12

21. DO NOT touch hot muffler, cylinder, or

fins because contact may cause burns.

22. DO NOT run engine without air cleaner

or air cleaner cover.

23. DO NOT operate during excessive

vibration!

24. DO NOT leave machine unattended

while in operation.

25. DO NOT park machine on a steep grade

or slope.

WARNING: DO

1. ALWAYS DO remove the wire from the

spark plug when servicing the engine or

equipment TO PREVENT ACCIDENTAL

STARTING.

2. DO keep cylinder fins and governor parts

free of grass and other debris which can

affect engine speed.

3. DO pull starter cord slowly until resistance

is felt. Then pull cord rapidly to avoid

kickback and prevent hand or arm injury.

4. DO examine muffler periodically to be

sure it is functioning effectively. A worn or

leaking muffler should be repaired or

replaced as necessary.

5. DO use fresh gasoline. Stale fuel can gum

carburetor and cause leakage.

6. DO check fuel lines and fittings frequently

for cracks or leaks. Replace if necessary

7. Follow engine manufacturer operating

and maintenance instructions.

8. Inspect machine and work area before

starting unit.

VIBRATION

Vibration levels at the operators handles were

measured in the vertical, lateral, and longitudinal

directions using calibrated vibration test equipment.

Tests were performed on 04/10/2000 under the

conditions listed:

SAFETY INSTRUCTIONS 2

GENERAL SAFETY 3

ASSEMBLY 3

LABELS 4

PARTS BAG & CONTROLS 4

OPERATION 5-6

MAINTENANCE 7-9

PARTS DRAWING & LIST 10-11

TROUBLESHOOTING 12

WARRANTY PROCEDURE 12

TABLE OF CONTENTS

VIBRATION LEVELS 3.2 g

SOUND

IN THE INTEREST OF SAFETY

BEFORE STARTING ENGINE, READ AND UNDERSTAND THE “ENTIRE OPERATOR'S MANUAL &

ENGINE MANUAL.”

THIS SYMBOL MEANS WARNING OR CAUTION. DEATH, PERSONAL INJURY AND/OR PROPERTY

DAMAGE MAY OCCUR UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY.

WARNING!

The engine exhaust from this product contains chemicals known to the State of California to cause

cancer, birth defects or other reproductive harm.

13. DO NOT tamper with governor springs,

governor links or other parts which may

change the governed engine speed.

14. DO NOT tamper with the engine speed

selected by the engine manufacturer.

15. DO NOT check for spark with spark plug

or spark plug wire removed. Use an

approved tester.

16. DO NOT crank engine with spark plug

removed. If engine is flooded, place throttle

in “FAST” position and crank until engine

starts.

17. DO NOT strike flywheel with a hard

object or metal tool as this may cause

flywheel to shatter in operation. Use proper

tools to service engine.

18. DO NOT operate engine without a

muffler. Inspect periodically and replace, if

necessary. If engine is equipped with

muffler deflector, inspect periodically and

replace, if necessary, with correct deflector.

19. DO NOT operate engine with an

accumulation of grass, leaves, dirt or other

combustible material in the muffler area.

20. DO NOT use this engine on any forest

covered, brush covered, or grass covered

unimproved land unless a spark arrester is

installed on the muffler. The arrester must

be maintained in effective working order by

the operator. In the State of California the

above is required by law (Section 4442 of

the California Public Resources Code).

Other states may have similar laws. Federal

laws apply on federal lands.

Sound tests conducted were in accordance with 2000/14/EEC and

were performed on 2/16/2002 under the conditions listed:

112 dB

WIND DIRECTION:

HUMIDITY:

TEMPERATURE:

BAROMETRIC PRESSURE:

GENERAL CONDITION:

29.94" Hg (760mm Hg)

49 %

South East

9 MPH (14.5 kmh)

60° F (15.6° C)

Sunny

WIND SPEED:

WIND DIRECTION:

HUMIDITY:

TEMPERATURE:

BAROMETRIC PRESSURE: 29.95" Hg (761mm Hg)

32 %

North

10 MPH (16.1 kmh)

60° F (15.6° C)

Sunny

WIND SPEED:

GENERAL CONDITION:

(QB1304 MODEL)

Sound level of 97 dBA at operator position

NOTE: Sound power level listed is the highest value for any model in this manual.

Please refer to serial plate on the unit for the sound power level for your model.

1 2 3 4 5 6 7 ... 11 12

Comments to this Manuals

No comments

Billy Goat QB1004 User Manual Page 2

Comments to this Manuals

Related products and manuals for Engine Billy Goat QB1004