Part No. 430316 Form No. F012203A
Page 5 of 12
HANDLING & TRANSPORTING:
OPERATION
16
Using two people to lift machine is recommended. Lift holding the
handle and handle brace. Secure in place during transport.
INTENDED USE: This machine is designed for cleaning
outdoor surfaces, where the debris can be effectively
blown into a consolidated area for convenient pickup and
removal.
ENGINE: See engine manufacturer’s instructions
for type and amount of oil and gasoline used.
Engine must be level when checking and filling oil and
gasoline.
FUEL VALVE: Move fuel valve to "ON" position (when
provided on engine).
STOP SWITCH: Located on the engine. "ON" position.
CHOKE: Operated with choke lever on side of engine .
THROTTLE: Controlled by throttle lever on the handle. Move
remote throttle control to fast position. Pull starting rope to
start engine.
ENGINE SPEED: Under normal conditions, operate at
minimum throttle to accomplish your current cleaning task.
IF YOUR UNIT FAILS TO START:
See Troubleshooting on page 12.
STARTING
16.1
Inspect machine work area and machine before operat-
ing. Make sure that all operators of this equipment are
trained in general machine use and safety.
PUT OIL IN ENGINE BEFORE STARTING
Like all mechanical tools, reasonable care must
be used when operating machine.
Do not operate if excessive vibration occurs. If excessive
vibration occurs, shut engine off immediately and check for
damaged or worn impeller, loose impeller bolt, loose
impeller key, loose engine or lodged foreign objects. Note:
See parts list for proper impeller bolt torque specifications.
(See trouble shooting section on page 12).
16.2
BLOWING OPERATION
16.3
Your Billy Goat blower is equipped with a remote exhaust
director to allow the operator to direct the air stream up or down
as required to assist in moving debris. This feature is extremely
useful when debris has piled up to the point that it cannot be
blown any farther. The air stream can be directed upward to
blow the top of the debris pile over and allow the operator to
continue moving more debris farther.
Side Discharge Up Position
Slide over to right to
lock in middle position
This position allows air to be directed upward during use to avoid
blowing debris into cars or other structures, or to avoid blowing
landscaped areas that would be damaged by the high speed air.
This position also allows operator to maneuver the machine
relative to the work area without disturbing the debris.
Side Discharge Straight Position
This position directs the air parallel to the ground for the
majority of blowing operations. The hand control allows the
operator to lock the air stream in this straight out position. To
LOCK the air in position simply pull back on the lever and pull
the lever sideways to the right until the lock engages. See
instruction label on the control.
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals